The Lyngdorf Audio designed switch mode power supply is extremely well regulated and is filtered and decoupled to provide a low noise and low impedance supply to the digital and analog circuitry. With different supplies from four independent secondary windings on the transformer, the analog and digital supplies are kept separate to minimize digital noise in the analog circuit. Grounding is optimal, and the entire chassis is connected electrically. The back panel is electrically conductive.
Lyngdorf Audio spends great time and effort in designing products that will not radiate noise. Making a noise and radiation free design has the advantage that it will also make the CD-2 itself immune to noise from the outside and from products that have not had the same attention to details in the design phase.
D/A converter
The D/A converter section is used to drive a high-quality, single ended, and balanced output stage. The D/A converter is built around the Wolfson WM8740 chip. This, in combination with our balanced design and very fine audiophile op-amps, results in outstanding sonic qualities.
Specifications
Outputs
1 x Coaxial Digital (galvanic isolated), 1 x Optical Digital, 1 x Analog Single Ended RCA, 1 x Analog Balanced XLR
Frequency Response
20 – 20k Hz, +/- 0.02dB
THD + N
0.0018%
Signal-to-noise ratio
114 dB (A)
Dynamic Range
100 dB (A)
Crosstalk
-120 dB (16 – 20.000 Hz)
Analog output level
3.5 V (RCA), 7.0 V (XLR)
Analog output Impedance
75 Ohm (RCA), 100 Ohm (XLR)
Sample Rates
44.1kHz,16 bit, 48/96/192kHz, 24 bit
Dimensions HxWxD
5.8 x 45.0 x 37.5 cm* / 2.3 x 17.7 x 14.8 in*, *incl front knob and connectors
Finish
Anodized aluminum, matte black
Weight
6.1 kg / 13.5 lb
