The Parasound ZoneMaster 2350 delivers 350 watts per channel, and it offers a wide variety of configuration options for custom installation and multi-zone audio applications. It can drive multiple speakers or subwoofers with ease, thanks to ample power output and a 2-ohm stable design.
Configuration flexibility
This amp features a three-position Output Mode switch that gives you multiple configuration options. In Stereo mode, it can drive A and B speaker pairs, such as in your main room or in a second zone. A built-in impedance switch means you can even use hard-to-drive 4-ohm speakers in this configuration.
In Mono mode, it's 2-ohm stable, which allows it to drive up to 8 speakers at the same time in a large room or outdoor space, all playing the same mono signal. In Sub mode, an 80 Hz low-pass filter is applied, so the amp can drive one or more passive subwoofers. And there's a stereo RCA loop output that lets you daisy chain additional amplifiers.
The amp can start automatically when your system is turned on via a 12-volt trigger, or when it senses an incoming signal. Buttons on the front panel let you engage A/B or A+B speakers, or you can use to rear-panel lockout switch to keep both pairs on at all times.
Product highlights
350 watts per channel into 8 ohms (20-20,000 Hz) at 0.05% THD with 2 channels driven
600 watts x 2 into 4 ohms (2-ohm stable with load selector switch)
2-ohm stable design enables it to drive multiple speakers
Class D amplifier with Class AB input stage
frequency response: 10-70,000 Hz (+0/-3dB)
signal-to-noise ratio: 114 dB
switchable high pass filter: off/30Hz/40Hz
three-position output mode switch: Stereo/Mono/Sub
unbalanced stereo RCA input
right and left level knobs (total gain of 28 dB)
four-pin Euroblock speaker-level input for integrating with audio systems that don't have a line-level output
stereo RCA loop output lets you daisy-chain additional amplifiers
dual mono RCA outputs
output 1: subwoofer only (low pass filter <80 Hz)
output 2: full range mono output for subwoofer or mono listening area
2 pairs of binding post speaker connectors
A+B speaker impedance switch: 2-3 ohms/4-8 ohms
front-panel A/B speaker selector buttons with rear-panel lockout switch
switchable turn-on options: manual, signal sensing, or 12-volt trigger
